Home > Uncategorized > How do you replace the handlebar grips of an average razor scooter?

How do you replace the handlebar grips of an average razor scooter?

by admin on February 7, 2010

I have the handles already, but need to know how to slide them on since it is a very tight fit; and seems literally impossible. I have an average razor scooter and would like to upgrade the handles since the others were totally riping off from wear.

Related Posts

{ 3 comments… read them below or add one }

dazed&confused February 7, 2010 at 11:30 pm

Cut them down the side put them on and then put duct tape over em.

Matthew February 8, 2010 at 12:27 am

If you have an air compressor you can put the nozzle inside the grip and turn it on and it will expand the grip and make it go on easier.

Jeff February 8, 2010 at 12:46 am

Use a air compressor and spray inside keep spraying and pull it off when you put it on spray any kind of hair spray in the grip so is decently wet(2 seconds) then put it on the use the air compressor to spray the inside clean.

Leave a Comment

Previous post:

Next post: